Dark Fury is cast when Agatha reaches 100% energy, so keep an eye on her energy bar - this will tell you when imps need to be dead by and when you should be saving cooldowns!.Save Meteor to burst down the Dark Fury shield - but make sure it doesn’t land on any imps.After this, she teleports on a timer - roughly every minute - so it’s important to keep the entire encounter area as clear as possible. Additionally, Fel Lava Blast will spawn underneath you - again, move out to avoid taking damage.Īgatha remains in place until she reaches 35%, at which point she teleports again. These take up a third of the room and will one-shot you if you get hit, so you must avoid them. This phase lasts until Agatha hits 50% health.Īll of the adds and abilities from phase 1 are active, but Agatha begins to teleport around the encounter area and drop boulders. Burst this down quickly, before she summons her first set of Umbral Imps (always three at first) if these channel the shield onto Agatha at the same time as she is using Dark Fury, you are likely to wipe.Ĭontinue dealing with mechanics in the same way, with the priority of Umbral Imp > Dark Fury > Imp Servant > Agatha. Next you will need to deal with Dark Fury: a large shield that must be broken before you can interrupt the spell. Counterspell or Dragon’s Breath if they get too close to Agatha. Frost Nova these and kill one, then the next. They can and should be killed in phase 1, but in phase 2 I recommend just moving to a convenient spot and allowing them to blow up.Īgatha will begin by summoning Smoldering Imps, followed shortly by two Imp Servants.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |